Tdc?

slob · 29-04-2020, 06:35 PM

Depends how hard you use it and whether whoever looked at it last time changed them, if it was only just out of spec. they may have decided 'near enough', did you get an itemised bill?
... but it certainly looks like all four closers could use a 0.05mm bigger shim, the openers are all within spec. (from memory I think it's 0.10 - 0.15mm)

I use one of these sheets http://www.thelasturl.net/ukmoc/Desm...tDatasheet.xls to keep track of my services so I can always refer back to what was previously changed

also, did you rotate the engine again and re-check, to make sure your measurements are accurate?

29-04-2020, 06:35 PM	#1
slob . Join Date: Jul 2003 Location: East London Bike: Multiple Monsters Posts: 9,713	Depends how hard you use it and whether whoever looked at it last time changed them, if it was only just out of spec. they may have decided 'near enough', did you get an itemised bill? ... but it certainly looks like all four closers could use a 0.05mm bigger shim, the openers are all within spec. (from memory I think it's 0.10 - 0.15mm) I use one of these sheets http://www.thelasturl.net/ukmoc/Desm...tDatasheet.xls to keep track of my services so I can always refer back to what was previously changed also, did you rotate the engine again and re-check, to make sure your measurements are accurate?