clutch slip at higher revs

hi on my recently aqiured 2001 m750 framed monster with a 900 engine(96) ive recently serviced it. now on the way home done the m2 when ever i pulled the throttle back at 5000plus revs the clutch slipped in the last few gears but when i came of motorway in lower gears i couldnt do it again when i gave it a hand full.can i adjust the clutch or is it not that.??????????????????????

No clutch adjustment i'm afraid. Check there is free play in the clutch lever, failing that it sounds like a new set of plates is needed. Straight forward job as the 900 has a dry clutch so you should only need m6 allen wrench to remove the cover and a m5 allen wrench to remove the 6 spring retainer bolts.

even though engine done 9k miles ,apriciate the reply though ill look into new plates

If you give a dry clutch enough abuse then expect around 4k and it will need replacing. Treat it well and you can get big milage out of one, my 748 has 21k from new on the original dry clutch.

thanks dude ill try and source some plates from somewhere

Originally Posted by dunlop0_1

If you give a dry clutch enough abuse then expect around 4k and it will need replacing. Treat it well and you can get big milage out of one, my 748 has 21k from new on the original dry clutch.

I just had the plates and basket replaced after 13,000 miles, both were pretty worn but I would appreciate any tips on how to get the most out of it.

[uksurfer]

Just changed mine at about 15,000.
it didn't slip at high revs, just when pulling away a bit quicker than normal
Think the plates were about £140 from Moto Rapido