Paddock Stand Bobbins - rear axle - Page 2

slob · 24-06-2021, 04:31 PM

careful tightening them up, it’s possible to pull the rod through, leaving one side with very little thread engaged.

hh93 · 24-06-2021, 05:07 PM

Quote:

Originally Posted by slob

careful tightening them up, it’s possible to pull the rod through, leaving one side with very little thread engaged.

Yes, the thread is just cut into the plastic - not to good. I'll be looking at an anchor-nut sort of thing if they loosen off.

Just need to do a bump test next against the Silencers to see if they clash - they'll soon shear off or dent the Silencers if they hit with much force. I guess they are made for Monsters with the Higher silencers.

slob · 24-06-2021, 07:08 PM

they should be ok as long as both ends are in the nylon, a regular eyeball to make sure nothings shifting will do, there’s very little pressure on on the rod

24-06-2021, 04:31 PM	#16
slob . Join Date: Jul 2003 Location: East London Bike: Multiple Monsters Posts: 9,713	careful tightening them up, it’s possible to pull the rod through, leaving one side with very little thread engaged.

24-06-2021, 07:08 PM	#18
slob . Join Date: Jul 2003 Location: East London Bike: Multiple Monsters Posts: 9,713	they should be ok as long as both ends are in the nylon, a regular eyeball to make sure nothings shifting will do, there’s very little pressure on on the rod