Non starter

22-04-2019, 02:03 PM

Charged the bike overnight and started no problem this morning. I brought it home and have it a wash and it won’t start now. I can here the fuel primer and the neutral light and oil light are coming on but the small yellow alarm/immobiliser light are NOT coming on and nor are the dials doing the ignition sweep round thing. Can anyone help?
It’s a 02 M750 dark 🙁

rollo22 · 22-04-2019, 04:28 PM

The antenna in the ignition switch housing may have come loose and slid down the barrel.

22-04-2019, 04:44 PM

I wondered if it could be something to do with ignition barrel. Should I open it up? But then what ?

Nickj · 22-04-2019, 05:38 PM

You shouldn't get any real issues with water on most parts with a hand wash. Use a pressure washer and water can get almost anywhere.

I'd check the key sensor ariel, but the clocks not sweeping would also have me looking elsewhere. My 750ie would do everything normally with the sensor ariel disconnected but the immobiliser would have kicked in, you could even spin the motor up but it just didn't fire.
So I'd disconnect the big plug into the clock set (clean and refit), visually check the loom down stream of the plug for damage. They can leak in water which can give current leaks between joins in the wires. Also check the fuses and relays.

23-04-2019, 07:41 AM

If the key sensor aerial is the thin wire that travels up to the top of the key barrel, it looks all in place and in fact it looks like it’s sealed there and I’m unable to remove it? I’ll try tidying up and looking at the wires behind the clocks later but with my zero knowledge of all things electronic and mechanic I’m not holding out much hope. I think in the past I’ve relied on the bike miraculously fixing itself in these situations

Nickj · 23-04-2019, 09:41 AM

Well even a miraculous fix is a good clue to what's going on.
If it does mend itself given the warm few days we're having then it's probably some damp shorting out a connection either at a connector or in the loom.

Darren69 · 23-04-2019, 11:07 AM

Trouble with that approach you don't find the root cause, so its still there waiting, lurking ready to fail again at some point.

23-04-2019, 03:25 PM

Okay, let’s approach it another way...what about the little yellow light in the middle of the dial casing that flashes periodically to show the alarm is on, isn’t flashing??

23-04-2019, 03:44 PM

Fixed it!!!! The ecu thing next to the battery needed wobbling about !!!! ��

mickj · 23-04-2019, 04:42 PM

My kind of fault finding, smack everything in turn until it starts

22-04-2019, 02:03 PM	#1
jimal1969 Guest Posts: n/a	Non starter Charged the bike overnight and started no problem this morning. I brought it home and have it a wash and it won’t start now. I can here the fuel primer and the neutral light and oil light are coming on but the small yellow alarm/immobiliser light are NOT coming on and nor are the dials doing the ignition sweep round thing. Can anyone help? It’s a 02 M750 dark 🙁

22-04-2019, 04:28 PM	#2
rollo22 Moderator Join Date: Apr 2008 Location: Moreton-in-Marsh Bike: M1100evo Posts: 1,083	The antenna in the ignition switch housing may have come loose and slid down the barrel. __________________ IF ALL ELSE FAILS READ THE INSTRUCTIONS

22-04-2019, 05:38 PM	#4
Nickj Too much time on my hands member Join Date: Jun 2007 Location: Forest Of Dean Bike: S2r Posts: 3,208	You shouldn't get any real issues with water on most parts with a hand wash. Use a pressure washer and water can get almost anywhere. I'd check the key sensor ariel, but the clocks not sweeping would also have me looking elsewhere. My 750ie would do everything normally with the sensor ariel disconnected but the immobiliser would have kicked in, you could even spin the motor up but it just didn't fire. So I'd disconnect the big plug into the clock set (clean and refit), visually check the loom down stream of the plug for damage. They can leak in water which can give current leaks between joins in the wires. Also check the fuses and relays. __________________ "The final measure of any rider's skill is the inverse ratio of his preferred Traveling Speed to the number of bad scars on his body." Song of the sausage creature

23-04-2019, 09:41 AM	#6
Nickj Too much time on my hands member Join Date: Jun 2007 Location: Forest Of Dean Bike: S2r Posts: 3,208	Well even a miraculous fix is a good clue to what's going on. If it does mend itself given the warm few days we're having then it's probably some damp shorting out a connection either at a connector or in the loom. __________________ "The final measure of any rider's skill is the inverse ratio of his preferred Traveling Speed to the number of bad scars on his body." Song of the sausage creature

23-04-2019, 11:07 AM	#7
Darren69 Transmaniacon MOC Join Date: Sep 2013 Location: Sutton In Ashfield Bike: Multiple Monsters Posts: 6,095	Trouble with that approach you don't find the root cause, so its still there waiting, lurking ready to fail again at some point. __________________ Roast Beef Monster! Termignoni and Bucci - Italian for pipe and slippers! S4 Fogarty, S4R 07T, 748, Series 1 Mirage

22-04-2019, 04:44 PM	#3
jimal1969 Guest Posts: n/a	I wondered if it could be something to do with ignition barrel. Should I open it up? But then what ?

23-04-2019, 07:41 AM	#5
jimal1969 Guest Posts: n/a	If the key sensor aerial is the thin wire that travels up to the top of the key barrel, it looks all in place and in fact it looks like it’s sealed there and I’m unable to remove it? I’ll try tidying up and looking at the wires behind the clocks later but with my zero knowledge of all things electronic and mechanic I’m not holding out much hope. I think in the past I’ve relied on the bike miraculously fixing itself in these situations

23-04-2019, 03:25 PM	#8
jimal1969 Guest Posts: n/a	Okay, let’s approach it another way...what about the little yellow light in the middle of the dial casing that flashes periodically to show the alarm is on, isn’t flashing??

23-04-2019, 03:44 PM	#9
jimal1969 Guest Posts: n/a	Fixed it!!!! The ecu thing next to the battery needed wobbling about !!!! ��

23-04-2019, 04:42 PM	#10
mickj Registered User Join Date: Jun 2018 Location: Clevedon Bike: M1200s Posts: 565	My kind of fault finding, smack everything in turn until it starts __________________ Keep the rubber side down. Mick