UK Monster Owners Club Forum » .: Technical :. » Electrics » A simple series of tests for your rectifier

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 10-08-2020, 02:30 PM   #1
Luddite
Registered User
 
Luddite's Avatar
 
Join Date: Aug 2011
Location: Southampton
Bike: M1100evo
Posts: 2,465
A simple series of tests for your rectifier

Ok, so this isn't a Ducati component, (it's actually from my Gilera), but the tests can be used on most rectifier units, including Monsters. Since Regulator/Rectifier (R/R) problems seem to appear quite frequently on the forum, I thought I'd share these tests as someone else might find them useful.

For identification purposes, this is a three-phase, full-wave, bridge rectifier using six diodes to convert the AC voltage from the alternator to DC voltage to the battery.


Simplified rectifier diagram


Gilera 5-wire rectifier

All of the current Monsters should similarly be three-phase (with three yellow wires), but the early versions had single-phase alternators (two yellow wires) and so will have a different R/R to suit. The Monster R/Rs also have dual positive (red) and negative (black or green) wires, (making seven in total), which are sometimes siamesed together as here.


Typical Monster 7-wire rectifier

My problem
I'd noticed that my battery was going flat despite being boosted by an Optimate.

Preliminary checks
The first suspect was the battery itself. Although it's only a couple of years old, it doesn't get used much so could have deteriorated. However, after fully charging it, it held 12.8V for a week, so then the alternator seemed a likely culprit.

Checking the voltage at the battery with the engine at 3,000 revs gave only a maximum of 12.5V when you'd expect high 13/low 14V, which again suggested the alternator.

An (external) check of the alternator with a multimeter suggested that it was working normally, so that just left the R/R, (all connecting wiring appeared fine).

I'd not really considered the R/R as usually, when it fails, it seems to result in overcharging rather than undercharging.

To check the rectifier component of the R/R, there are four tests to be made on each of the three alternator connections (12 in total). So first turn your meter to the diode check facility:


Last edited by Luddite; 10-08-2020 at 02:44 PM..
Luddite is offline   Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 09:55 PM.

vBulletin Skins by vBmode.com. Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.