Fitting Restrictors to a Monster

So last night I set upon fitting the 33bhp restrictors to my M600. After reading the instructions etc. I set about the task.


With the seat removed and tank lifted
Remove the complete Air Filter to exposing the carbs
The restrictor plate sits on the manifold side inbetween the rubber hose that mounts the Manifolds to the Carburettors, with the point of the triangle cut out facing forwards
Loose the hose clamps and pop separate from the manifold
Remove the rubber hoses and fit the restrictors to the underside, so that when replaced back on the manifold it the restrictor will be at the bottom.
Then it's a matter of putting everything back together.

The restrictor plates were a perfect fit and the instructions suggest you use some silicone or alike to assist in the sealing of the restrictors.

I have attached pictures 1-6