Quote:
Originally Posted by Mr Gazza
I did wonder if there was not enough wind there.
My little compressor can pump 9.5cfm, but I run the wrench off the unregulated air @ 115psi. The compressor cuts in very soon after I pull the trigger and can't keep up, if I hold it.
So I'm guessing there is not enough volume there? Not much point me looking at other wrenches if the compressor is not good enough suppose.
It says 90psi on the box, but no sure what that means, precious little info supplied. I just assumed 115psi would do the trick.
|
Its not the pressure that’s the issue it’s the flow rate, the cfm