Scraped an hour in the garage today and roughly trimmed both the rear light holder and the number plate holder. The number plate holder needs to be trimmed at an angle at the top so that it clears the tyre on full suspension compression. I think once I have determined the angle I will bond a plate of CF on the top to stiffen the structure, also I need to make the plate to attach to the two truncated frame rails put two slots in the side of the holder then bond that in. I am currently thinking this holder will be semi-permanently attached to the seat so that seat removal will consist of undoing the latch, removing the two bolts to the frame rails and disconnecting the rear wiring AMP plug and the camera cable inside the hump.
I had originally envisaged leaving the number plate on the bike and connecting the two with Dzuz fasteners but the number plate lights and associated wiring will make this a bit messy.
