Today I have been working on a 3D printed version of the early Monster choke holder when it was mounted there.
The part is no longer available I dont think and it is also a part that will not fit when handle bar raisers are installed as might happen when a fork conversion pushes the stanchion through the top yoke.
The first proto type seems to work well, and clamps nicely in place, but is bearing on the yoke nut chamfer rather than the head of the nut.
If this is successful, it should be able to be printed in any height, given the critical dimension between the u/s of the bar and the top of the yoke nut. And obviously in black