UK Monster Owners Club Forum - View Single Post

buzzer · 06-12-2020, 09:50 AM

the rebuild of the heads is going well… some of the clearances are out though, not surprising as I gave the valves a bit of a grind in and replaced the half rings. I have a little spreadsheet that I put the values in, which calculates everything from there, and also mirrors the measurements in MM rather than the thous I prefer to work in. Old school I know!

Been doing the plating on and off, its time consuming, but I put parts in the bucket, set the timer so I don’t forget, and the magic happens… just a few parts to go…

frame and wheels are back from the powder coater, and its another superb job….

06-12-2020, 09:50 AM	#49
buzzer Registered User Join Date: Jun 2018 Location: Wolverhampton Bike: M900 Posts: 392	the rebuild of the heads is going well… some of the clearances are out though, not surprising as I gave the valves a bit of a grind in and replaced the half rings. I have a little spreadsheet that I put the values in, which calculates everything from there, and also mirrors the measurements in MM rather than the thous I prefer to work in. Old school I know! Been doing the plating on and off, its time consuming, but I put parts in the bucket, set the timer so I don’t forget, and the magic happens… just a few parts to go… frame and wheels are back from the powder coater, and its another superb job….